How do I re-APPLY (refresh) CA Jobtrac Job Management Usermod UM00001 ?

Products

• Jobtrac

Issue/Introduction

Question: 

How do I re-APPLY (refresh)  CA Jobtrac Job Management Usermod UM00001 ?

UM00001 is the usermod for JES2 customers that are using the AUTO-SCHD feature.

 

 

Environment

Release: JOBT..00200-11-Jobtrac-Job Management
Component:

Resolution

To manually re-APPLY Usermod  UM00001,  the SAMPJCL member HD11JES2 can be used as a model.

Make sure you are using the correct JES2 MACLIB library on this job. 

1. Run SAMPJCL HD11JES2 job to re-APPLY the UM00001 Usermod.

2. IPL or issue z/OS console command F jobtrac,BACK 
   This reloads the IEFUJV Exit. BACK is used to back out the internals loaded by Jobtrac. 
   
   
3. If you do not IPL depending upon LINKLIST or STEPLIB usage (for Jobtrac and mod GJTRJES), an F LLA,REFRESH is needed prior to the re-cycle of Jobtrac.
   
   
4. Then start Jobtrac again issue the z/OS console command S jobtrac 

 

This has to be done on each system to pick up the change.