VCF Automation Upgrade Fails At "Inventory sync post VCF Automation upgrade" Stage
search cancel

VCF Automation Upgrade Fails At "Inventory sync post VCF Automation upgrade" Stage

book

Article ID: 457537

calendar_today

Updated On:

Products

VCF Automation

Issue/Introduction

  • When upgrading VMware Cloud Foundation (VCF) Automation from version 9.0.1 to 9.1.1, the process fails during the "Inventory sync post VCF Automation upgrade" phase at the "Reset VCF services runtime password" task.
  • The following error details are observed in the task execution logs:
    1. An unexpected error occurred in step reset_vsp_component_password_task_ref. Reference Code:A3CEC75F. Please contact support with this reference code.
      Detail: Failed to reset password for VCF services runtime component with type "VCFA'. Cause: 404 Not Found on POST request for "https://<VCFA_FQDN>:443/tm/cloudapi/1.0.0/sessions/provider": [no body]
    2. Step post_upgrade_inventory_sync failed. Reference Code:98964DE1. Check logs for details.

Environment

VCF Automation 9.1.1

Cause

This issue occurs when the same FQDN is configured for both the VCF Services Runtime and VCF Automation during upgrade setup.

Resolution

To resolve the issue:

  1. Rollback the failed VCF Automation upgrade to the previous version. Please contact Broadcom Support for assistance with the rollback process.
  2. When configuring the upgrade for the VCF Automation (VCFA) component, specify a unique FQDN for the VCF Services Runtime that is distinct from the VCFA FQDN.
    Note: Please ensure that all FQDNs are written in lowercase and avoid using camel case

  3. Confirm that valid forward (A record) and reverse (PTR record) DNS entries are pre-configured for the new VCF Services Runtime FQDN before proceeding.

  4. Retry the VCF Automation upgrade.

Additional Information

Perform the Upgrade to VCF Automation 9.1