Error messages: $RS8D04 and $RS8D06

Products

• RSVP

Issue/Introduction

Executing $RSVP jobs to acquire large amounts of data for reporting purposes. Receive the following error messages:

$RS8D04 NOT ENOUGH TABLE STORAGE FOR THIS REQUEST
$RS8D06 USE NOSORT OR INCREASE GETMAIN SIZE.

 

 

 

 

 

Environment

Release:
Component: RSVP

Resolution

This problem is normally encountered when using RSVP to report on large amounts of data and using RSVP's internal SORT logic. To help with this situation the following changes can be made to the table definitions in RSVP.

In the RSVP.CAISRC ($RSUSER) member add the following lines after the 'COPY $RSUSR00' line and before the '$RSUEND, ' line:

* * FOLLOWING MODIFIES THE BLKTBL TABLE AND VOLTBL.
*
$RSUD CHG,BLKTBL=(xxxxxx,0),VOLTBL=(xxxxxx,0)
*

Then modify the xxxxxxx to appropriate values.

A good starting point will be;

$RSUD CHG,BLKTBL=(300000,0),VOLTBL=(100000,0)

If this value is not sufficient, consider increasing the value in increments of 20000. As a rule of thumb, the VOLTBL will always be 1/3 of the BLKTBL.

Use the RSVP.SAMPJCL(ASM$RSVP) member to assemble the change.

Additional Information

For more information on this subject please see the RSVP GUIDE Chapter 5.