Alerts seen in HP Synergy UI when configuring LACP in the VirtualConnect module for ESXi hosts
Article ID: 443991
Updated On:
Products
Issue/Introduction
After configuring LACP between the chassis and blades running ESXi hosts, there are alerts seen in HP Synergy as follows:
Rebooting the ESXi hosts has no effect.
From the perspective of vCenter Server, and ESXi hosts, the LAG is correctly configured and is in use by the DVS. This can be validated by running the utility esxtop via SSH to the ESXi host, and then pressing "n" to see the networking view. The TEAM-PNIC column shows that the LAG is in use.
Environment
VMware vCenter Server
VMware ESXi
Cause
This is a result of misconfiguration inside HP Synergy.
Resolution
Contact HPE Support to troubleshoot further.
Additional Information
The following KB must be reviewed to verify correct LACP configuration on ESXi/vCenter Server:
Link Aggregation Requirements for ESXi (EtherChannel, Port Channel, LACP)
Feedback
