Failover Recovery Plan stuck or incomplete in VMware Live Recovery
search cancel

Failover Recovery Plan stuck or incomplete in VMware Live Recovery

book

Article ID: 443108

calendar_today

Updated On:

Products

VMware Live Recovery VMware vSphere ESXi

Issue/Introduction

  • The Failover Recovery Plan task remains stuck at percentage (e.g., 84%) in the vCenter Recent Tasks pane.
  • The Failover Recovery Plan task remains stuck at percentage (e.g., 96%) in the vCenter Recent Tasks pane.
  • Virtual machines (VMs) appear powered on at the target site, but the Recovery Plan status does not update to "Completed."
  • Virtual machines (VMs) appear powered on at the target site, but the IP has not been reverted as expected.
  • Restarting the vCenter Server or the Site Recovery Manager (SRM) appliance does not resolve the issue.

Environment

VMware Live Recovery 9.0, 9.0.1, 9.0.2, 9.0.3, 9.0.4, 9.0.5

Cause

The issue occurs when a Recovery Plan task becomes hung or enters an incomplete state, often due to a failure in previous attempt.

Resolution

For Recovery hung at 84%

  1. Navigate to the Site Recovery UI.
  2. Select Recovery Plans and locate the stuck plan.
  3. Manually Cancel the current "In Progress" or "Incomplete" Recovery Plan.
  4. Verify the plan status changes to "Recovery Interrupted" or "Completed."

For Recovery hung at 96%

When a VMware Live Site Recovery (VLSR) failover or test failover hangs at
96%, it almost always indicates that the VMs have successfully powered on at the disaster recovery (DR) site, but VLSR is waiting for a VMware Tools heartbeat or an IP customization script to complete.

  • Ensure VMware Tools is running on failed over guest. Manually start tools guest on if possible. 
    NB: Whenever possible, always keep VMware Tools uptodate on protected VM and synced.

  • IP customization requires uploading a script from VLSR to the local ESX host and further into the guest OS. 
    Ports 902 & 443 are required to be open for this.

    Test VLSR to local host connectivty
    # nc -z {ESX} 902     ie: nc -z ###.###.###.### 902
    # nc -z {ESX} 443     ie: nc -z ###.###.###.### 443

     
          

Additional Information

If the task remains visible in vCenter Recent Tasks but is finished in SRM, follow Clear stale tasks from the vCenter "Recent Tasks" panel

Checking required ports VMware Ports and Protocols

  •