The Secondary SpectroSERVER is starting as precedence 10 after restoring to the legacy.SSdb

Products

• CA Spectrum

Issue/Introduction

The Secondary SpectroSERVER is starting as precedence 10 after restoring to the legacy.SSdb

Environment

Release: Any version of Spectrum
Component:

Cause

Anytime you initialize the database to the legacy.SSdb you are initializing the database and starting over with a clean database. Therefore the fault tolerance setup is also removed and the database will load and run with the default precedence 10.

Resolution

Reconfigure the secondary SpectroSERVER system as Fault Tolerant to the primary SpectroSERVER as discussed in the "Establish Fault Tolerance" section of the Spectrum documentation.