ESPCOM not showing new address by ESP AGENT SET ADDRESS command

Products

• ESP Workload Automation

Issue/Introduction

Following command issued from ESP page mode to change the agent address:
OPER AGENT AGNTX SET ADDRESS(new_address)

But ESPCOM DEST(AGNTX) still shows the previous address:
AGNTX        |active|Send OK  11.41.15 20 MAY|   123|     0|old_address

Environment

Component: Workload Automation System Agent
Release: ALL

Resolution

ESPCOM output shows the past communications to the agent, and if there is no new communication after the change, it won't show the new address.

So "OPER AGENT AGNTX" should be used to check the current agent address.