Procedure to update Data Source in VMware Aria Operations for Networks (AON)
search cancel

Procedure to update Data Source in VMware Aria Operations for Networks (AON)

book

Article ID: 439600

calendar_today

Updated On:

Products

VCF Operations for Networks VMware vSphere ESXi

Issue/Introduction

This KB outlines the procedure for updating a data source in VMware Aria Operations for Networks (AON), using NSX and vCenter as examples. This procedure is required when the data source IP address changes or when a Fully Qualified Domain Name (FQDN) must be used in place of an IP address.

To update the data source, complete the following steps:

  1. Remove the existing data source from the AON user interface (UI).
  2. Wait approximately two to three hours.
  3. Re-add the data source to the AON UI.

Environment

  • VMware Aria Operations for Networks 6.13.0
  • VMware Aria Operations for Networks 6.14.x

Resolution

Follow the example procedure below to update NSX or vCenter data sources in VMware Aria Operations for Networks (AON).

1. Remove the existing data source from the AON UI

  • In the VMware Aria Operations for Networks GUI, navigate to Settings > Accounts and Data Sources.
  • Select the affected data source (NSX or vCenter) and click Edit.
  • Under Additional Details:
    • For NSX, clear the DFW IPFIX and Latency metric collection checkbox.
    • For vCenter, clear the NetFlow (IPFIX) checkbox.
  • When prompted, click I Acknowledge.
  • Click Submit to save the changes.

For NSX

  • Log in to the NSX Manager UI and navigate to Plan and Troubleshoot > IPFIX.
  • Verify that the vrni-IPFIX profile and associated collector configuration have been removed from the DFW IPFIX tab.

For vCenter

  • Log in to the vCenter Server UI and select the associated Distributed Virtual Switch (DVS).
  • Navigate to Configure > Settings > NetFlow and verify that the configured collector IP address and port have been removed.

Delete the data source

  • Return to Settings > Accounts and Data Sources in VMware Aria Operations for Networks.
  • Disable the Data Collection toggle for the data source.
  • Click the three-dot menu (⋮) for the affected NSX Manager or vCenter data source and select Delete Data Source.

2. Wait for cleanup to complete

  • Wait approximately 2 to 3 hours to allow the removal process and associated cleanup tasks to complete.

3. Re-add the data source

  • Re-add the data source using the updated IP address or FQDN.

Refer to the VMware documentation below and follow the procedure described in the Procedure section:

Add VMware NSX-T Manager 

Add VMware vCenter Server