AWI: Workflow editor - PromptSet and Scroll bar selection are not persistent

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

The PromptSet Selection within the Workflow Task properties do not remain when switching between tasks in v24. 
The scroll position within a tab does not remain in selection within the Time & Dependencies tab while switching between tasks in V24
This was working in V21

 

Steps to reproduce

Promptset issue:

• Add 3 Prompt sets to a job and include the job in the workflow
• Select the job, go to Properties > Promptsets tab, and select the 3rd or 2nd promptest
• Now, click on the Workflow Editor or a different task within the Workflow, then return to Properties > Prompt Sets tab — the selection defaults back to the first prompt set
  Problem: The user needs to manually reselect the 3rd Promptset again whereas in V21 the selection is retained after each switch or clicking on the Workflow Editor and returning

Time & Dependencies issue:

• Open the Workflow, select the job, then go to Properties > Time & Dependencies > Scroll to the middle or bottom > Select Dependencies and update the status
• Now, click on the Workflow Editor or a different task within the workflow, then return to the Properties of the same job > Time & Dependencies tab — the scroll position within a tab  resets to the top
  Problem: You have to scroll down every time when switching between tasks whereas in v21 the scroll bar remains in the position it was last set

Cause

DE175435

Resolution

Solution:

Update to a fix version listed below or a newer version if available.

Fix version:

Component(s): AWI

Automation.Engine 26.1.0 - Planned release June/July 2026