Introduction:
I’m running CA DATACOM/AD 11.0 SP04 with CA-11 and need to upgrade to CA Datacom/AD 14.0 . Can you help me with this ?
Environment:
z/OS
Instructions:
First read the CA Datacom/AD 14.0 README file RI61958 .
There are a number of solutions that you need to have applied before starting the upgrade .
It is recommended to install all available CA Datacom 14.0 maintenance .
CA Datacom/AD 14.0 does not use a Datacom SVC anymore but now uses PC CALL modules DBPCCPR and DBPCSPR .
Those modules are installed via CAIRIM and that requires that CAMASTER is running on the LPAR .
Steps that you need to run are :
1) perform a new installation for CA Datacom/AD 14.0 :
After running the SMP/e jobs , run AD 14.0 INSTJCL :
AXRIM01
Installs the PC CALLS.
AXAPFADD
Is a CA SYSVIEW example to dynamically add libraries to be APF listed.
AXCUS01
Has all the customization for the CA Datacom/AD MUF.
AXNEW01
Allocates and populates all the datasets needed by the 14.0 CA Datacom/AD MUF.
AD14STRT
Is the sample JCL to start the MUF.
AXIVP01
Is a sample install verification JOB.
2) when you are ready to switch over from AD 11.0 to 14.0 run AXPOR02 .
Both the 11.0 and the 14.0 MUF must be up when you run AXPOR02 .
If AXPOR02 completes successfully then shut down the 11.0 MUF and start CA-11 using the Datacom/AD 14.0 CUSLIB/CAAXLOAD .
Additional Information:
Have a look at the CA Datacom/AD 14.0 installation guide for z/OS