Avi SE VM that was previously sending traffic in one port group has switched to another

Products

• VMware NSX

Issue/Introduction

• Avi SE was attached to a port group and was sending traffic normally, but unfortunately the port group was removed from the Avi SE 
• The dvPort block and unblock event was observed on vcenter as shown below during the same timestamp 

Environment

NSX 4.2.3.1.0

Avi LB 30.2.1

Resolution

If such an issue is seen on the setup raise a support request with Broadcom following KB 142884 . 

Collect logs and support bundles from below components and upload to the support request

• NSX Manager 
• ESXi Logs on which Avi SE was deployed 
• vcenter logs

And below logs for Avi SE

• AVI Debug logs
• SE tech logs