AWI 24.x selected line always on top in the execution list - execution

Products

• CA Automic One Automation

Issue/Introduction

If you look at the execution list of a specific execution of a job (via right-click-> Execution List-> Execution), that specific execution is at the top of the list; not the last execution, this occurs only if all executions do not fit on one page. If there are fewer executions than lines, the last execution is at the top.

This can be confusing and lead to think there were no newer executions incorrectly.

 

Environment

Automic Web Interface 24.x

Cause

DE170453: A problem has been fixed when displaying executions in Execution List view. With the correction, the selected item shows with an offset 3 rows on top of the table.

Resolution

Update to a fix version listed below or a newer version if available.

Fix version:
Component(s): Automic Web Interface (AWI)

Automation.Engine 24.4.4 - Planned release March 2026