Portal Group rule configuration doesn't show correct group selected

Products

• Network Observability
• CA Performance Management

Issue/Introduction

Setting up the rules if choosing one group it sometimes works fine. Sometimes it chooses the wrong group. Go to change it and it again chooses a different group from the one displayed.

Open a Portal Group for editing. Edit the group rules for membership.

Open the Group selection UI to choose a group to target for membership.

Arrow down to another group and choose save. The wrong group is set.

Environment

All supported Network Observability DX NetOps Portal web server releases 25.4.3 and earlier

Cause

UI defect introduced somewhere between after 24.3.4

Resolution

Workaround: The correct group can be set, after arrowing down to the correct group, by using the space bar or right direction arrow.

This will properly select and set the UI focus to the target group. When then selecting save it should show the correct selected group for use in the rule.

Engineering is resolving this through defect ID DE180405. The current ETA is a fix will be included in the 25.4.5 GA release. This is subject to change.

Watch the PM Resolved Issue documentation list for an entry related to DE180405 to validate the target release includes a resolution.