Is it possible to run additional commands when using Spectrum NCM Self Certification

Products

• Network Observability
• Spectrum

Issue/Introduction

We have moved away from using PERL scripts to the NCM SSH Self Certification to gather our network configs.

We would also like to run some additional commands to be added to the configuration at the end such as "show ip arp" and "show mac address-table"

Is it possible to add these commands when using the NCM Self Certification and have the additional data stored the the ncm configs?

Environment

Spectrum. ANY

NCM SSH Self Certification

Resolution

It is not possible to run additional commands as the NCM SSH Self Certification is only designed to run a single command such as "show running config"

Once the capture command completes no further data will be stored to the NCM config.

If you require this functionality you will still need to use perl scripts for NCM capture.