Introduction:
Instructions on how to configure Autosweep using XPSConfig.
Question:
How to configure Autosweep using XPSConfig?
Answer:
Open a command prompt on the machine hosting the Policy Server.
Enter the following command:
XPSConfig
The Products Menu opens and lists the products.
Enter L to Login.
Enter the user path for your administrator.
Enter XPS for Extensible Policy Store.
The Parameters Menu opens and lists the XPS parameters.
Enter 7 for Autosweep.
The Autosweep Parameter Menu opens.
Verify that the Autosweep value is set to TRUE or enter C to Change the value to TRUE.
Note: This step specifies running XPSSweeper according to the Autosweep Schedule.
Enter Q to exit the Autosweep Menu and return to the Parameters Menu.
Enter 8 for AutosweepSchedule.
The AutosweepSchedule Parameter Menu opens.
Enter C to Change the value of the AutosweepSchedule parameter.
Enter 22:00 for the New Value.
Note: This step specifies running XPSSweeper nightly at 10:00pm GMT.
Enter Q three times to exit the AutosweepSchedule Menu, Parameters Menu, and Products Menu and return to the command prompt.
Note: You have to restart the policy server after changing this Value.
Additional Information:
N/A