search cancel

The function of the "" property


Article ID: 41783


Updated On:


CA Application Test CA Continuous Application Insight (PathFinder) Service Virtualization


It has been suggested that I set the property in order to avoid live invocation errors. What is this property and what does it do?



All supported DevTest releases.




The VSE (Virtual Service Environment) attempts to optimize the use of sockets use when communicating with the live system when a virtual service is in live invocation mode. 

In order to achieve this, the sockets, once opened, are held in a pool pending potential reuse. 

However, if the live system disposes of the socket while it is still present in the pool, then attempting to reuse it will result in an error. This is often seen in the inspection view for the service as "The live system did not send a response." 

It is therefore necessary to configure the VSE to cause the socket to be eliminated from the pool before the live system has taken this action. 

The property controls the time for which an idle socket may be held in the pool awaiting reuse.

This property has a default setting of 2 minutes (120 seconds) which may be overridden by placing an entry in the file.

For instance, to set the period over which a socket is held in the pool after its last use to 20 seconds, one may add

to the file. The actual maximum value will depend upon the behaviour of the live system, but, in order to ensure that there are no errors arising from reusing stale sockets using a time equal to or less than half of the expiry time within the live system would be prudent.

For example, if the live system expires sockets after they have been unused for 60 seconds,  then set as an initial value, and reduce it further only if issues are still encountered. 

After making the change to the file, the VSE will have to be restarted.