ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

After the installation of CA InterTest Batch 9.1, after selecting the Batch Jcl Conversion option, I receive the following error: "Empty BJCL Chain changed".

book

Article ID: 41340

calendar_today

Updated On:

Products

InterTest - CICS InterTest - Batch

Issue/Introduction

Symptoms:

After the upgrade to CA InterTest Batch 9.1, in panel INTCOBO3 (Batch Link Jcl Conversion PANEL), you receive the following message:

INTCOBO3 ------------- Batch Link Jcl Conversion PANEL ------- Empty BJCL Chain changed.

Additionally you also receive:

CSV003I REQUESTED MODULE CAMRAJ70 NOT FOUND
CSV028I ABEND806-04 JOBNAME=CAMRAUTL STEPNAME=ALIB

Environment:

CA InterTest Batch 9.1

Cause:

CA InterTest Batch 9.1 includes the new CA JCLCheck Common Component 12.0

Resolution:

Usually this error occurs if the CA JCLCheck library dataset is not correctly authorized.

1.    Execute TSO ISRDDN LOAD CAZ2RLSE command from InterTest Batch, and verify if the CA JCLCheck Common library is in a "not authorized" libraries chain.

2.    Verify the CAZ2CTSO entry is added into the AUTHTSF table of IKJTSO00.

Additional Information:

The CA InterTest Batch installation considerations about CA JCLCheck can be found in the CA InterTest Batch Installation Guide Release 9.1 manual.
Information about how to APF authorize CA JCLCheck can be found in the CA JCLCheck Common Component Installation and Configuration Guide Version 12.0 manual.

Environment

Release: OSINBV00200-9.1-InterTest-Batch
Component:
Powered by Wolken Software