When opening a project with Microsoft Project (MSP) with the New Driver, the project opens with an error "We're sorry. There seems to be a problem with this file that keeps us from opening it. Please try using a backup copy if available." or may be missing tasks, charge codes, and/or task notes. (Symptoms vary based on MSP Bit level used)
Steps to reproduce
1. Install the MS Project 2013 with the MSP New Driver
2. Create a new project in PPM
3. Export the project to MS Project
4. In MSP, create a task, charge code, or task note with a special character in the name, such as:
Note that the quotation marks and apostrophes that are impacted by this issue are different than the ones that are created in either MSP or PPM. These are special characters created in another application such as Microsoft Word and copied and pasted into MSP or PPM.
" This is one that was created in MSP or PPM. This one does not cause an issue opening/saving the MSP File.
“ This is one that was created in another application such as Microsoft Word. This one causes an issue opening/saving the MSP File.
5. Save the project back to PPM
6. Export the project back to MSP
Project opens in MS Project with all tasks, notes, and charge codes.
MS Project (32-bit): Errors with "We're sorry. There seems to be a problem with this file that keeps us from opening it. Please try using a backup copy if available." When clicking OK to the message, the project opens a blank project with the PPM project ID.
MS Project (64-bit): Project tasks, charge codes, and/or tasks notes are missing from the project.
Note: If you are uploading a new project from MSP to PPM that has one of the special characters with the issue, it may show you a different error message (a Target Error referencing Error: Attempted to read or write protected memory. This is often an indication that other memory is corrupt.)
This issue is caused by CLRT-80925
This issue applies to the MSP New Driver with CA PPM 14.3, 14.4, and 15.1
This issue is fixed in CA PPM 14.3 patch 10, CA PPM 14.4 patch 6, CA PPM 15.1 patch 3 and CA PPM 15.2.
For MSP 2013 (x32): Open the local XML file on your computer using a program such as Notepad++. Notepad++ will throw an error such as: "XML Parsing error at line X: xmlParseCharRef: invalid xmlChar value". Line X shows the task name/note that contains the special character that needs to be changed/ removed in PPM to allow the project to open in MSP without error.
For MSP 2013 (x64): Remove and retype tasks, charge codes, and/or notes that are blank or missing from MS Project in PPM.
Tip: A quick way to find out if there is a special character causing the issue is the below to see the local XML file that gets created for the project.
NOTE: The following special characters are not impacted by this defect:
Reference KB000071385 - CA PPM and MSP integration - List of Knowledge Documents
Reference KB000015956 - CA PPM and MSP integration known defects - Support Technical Document Index
Reference KB000091838 - MSP Error: 'We're sorry. There seems to be a problem with this file' due to issue with Notes