Unable to configure Segment Bridge Profile with single VLAN ID range

Products

• VMware NSX

Issue/Introduction

• Attempting to configure segment bridge profile config with a single VLAN ID range (e.g. 71-71) via API or UI returns an error message.

Environment

4.2.2.1 and earlier

Cause

Segment bridge profile config VLAN validation is too strict and does not allow configuring with a single VLAN ID range.

Resolution

This is a known issue and is fixed in versions below:
4.2.3 
9.0.1 

Workaround:

Configure segment bridge profile config with a multiple ID range (e.g. 70-71). If other traffic in the datacenter is already using a VLAN ID in the range, it should not be impacted as long as it is being transmitted on a different edge node VLAN uplink.