GIM54502E errors applying Telon PTFs

Products

• Telon Application Generator

Issue/Introduction

An attempt to apply various Telon PTFS may result in messages such as these.

RO57080  CWL5100  GIM54502E      3   ALLOCATION FAILED FOR SDFHLOAD BECAUSE THERE IS NO DD STATEMENT IN THE JCL AND
                                      NO DDDEF ENTRY IN TARGET ZONE CAIT0.

RO92832  CWL5100  GIM54502E      3   ALLOCATION FAILED FOR SDFHLOAD BECAUSE THERE IS NO DD STATEMENT IN THE JCL AND
                                      NO DDDEF ENTRY IN TARGET ZONE CAIT0.

SO09928  CWL5100  GIM54502E      3   ALLOCATION FAILED FOR SDFHLOAD BECAUSE THERE IS NO DD STATEMENT IN THE JCL AND
                                      NO DDDEF ENTRY IN TARGET ZONE CAIT0.

Environment

Release: 5.1.

Cause

CICS is not in use and therefore there is no DDDEF for SDFHLOAD in the CSI.

Resolution

Create a dummy DDDEF for SDFHLOAD.

To do this, follow these steps ...

1. Open a support case referring to this KD - 408496 - and request the stub SDFHLOAD module.
2. A support technician will provide the module in the "files_from_broadcom" directory of the support case.
3. Download it to a PC.
4. FTP it to the mainframe using the following sample FTP commands:
   
   binary
site lrecl=80 blksize=3120 recfm=fb pri=30 sec=5 cyl
put 'xmit.cics.sdfhload' 'hlq.sdfhload.rcv'


5. Use TSO RECEIVE to receive the stub load library. Example:
   
   TSO RECEIVE INDSNAME(hlq.SDFHLOAD.RCV) DSNAME(hlq.SDFHLOAD)
   
   
6. Define a DDDEF to the CSI for the received load library:
   
   ADD DDDEF(SDFHLOAD)
    SHR DA(hlq.SDFHLOAD)

The PTFs should now APPLY successfully.