TRACWARN - STG area at nn% full

Products

• Jobtrac

Issue/Introduction

Error message TRACWARN -  STG area at  nn% full is occurring in the Jobtrac log.  How do you recover from this error?

Resolution

 The STG area normally resets to 0% once schedule loads complete.   As such, the nn% value can be misleading due to an index issue.     To address this,  run  the sample job below to perform a Retix to rebuild the index area.   All Jobtrac accessing the 161 DBID will have to be down for this job to run.

//******************************************************************
//*                                                                *
//*     SAMPLE INDEX RE-BUILD JOB                                  *
//*     THIS JOB READS THE DATA AREAS AND RE-BUILDS THE            *
//*     IXX INDEX FOR THE DATABASE.                                *
//*                                                                *
//*     GENERALLY THIS WILL BE USED AT SUPPORT'S REQUEST.          *
//*                                                                *
//*     THE CA-DATACOM MUF MUST BE ACTIVE.                         *
//*     CA-JOBTRAC MUST BE INACTIVE AND ALL CA-JOBTRAC TSO USER'S  *
//*     MUST BE OUT OF CA-JOBTRAC'S ISPF INTERFACE.                *
//*                                                                *
//******************************************************************
//*
//RETIX  EXEC   PGM=DBUTLTY,REGION=2M
//STEPLIB  DD   DSN=DATACOM.CUSLIB,DIAP=SHR
//         DD   DSN=DATACOM.CAILIB,DISP=SHR
//CXX      DD   DSN=DATACOM.CXX,DISP=SHR
//SORTWK01 DD   UNIT=3390,SPACE=(CYL,(50,50))
//SORTWK02 DD   UNIT=3390,SPACE=(CYL,(50,50))
//SORTWK03 DD   UNIT=3390,SPACE=(CYL,(50,50))
//SYSIN    DD *                                   COMMAND INPUT
 ACCESS STATUS=OFF,DBID=161,USERS=WAIT
 INIT AREA=IXX,DBID=161
 RETIX DBID=161,OPTIMIZE=YES,SORT=9999999,OPTION1='I'
 ACCESS STATUS=WRITE,DBID=0161
//