Setting the Trace Level in Automation Point

Products

• Automation Point

Issue/Introduction

How do I set the trace level in Automation Point?

Environment

AP 11.7 and higher

Cause

  

Resolution

Setting the trace level is typically done via the Infrastructure Component:  

Select the Expert Interface

Select the Infrastructure

Then set the Security Level accordingly.  It is recommended to run at Trace Level 3 or 2, unless instructed otherwise.

 

 

 

Additional Information

Trace level info :
==================

1 - fatal errors (only) 
2 - error messages (additional to 1)
3 - warning messages (additional to 2)
4 - informational messages (additional to 3)
5-8 - extra trace/debug settings needed (together with /t)
6 - trace level for CCI logging