How to recycle CA OPS/MVS OPSUSS Servers?
Article ID: 40673
Updated On:
Products
Issue/Introduction
Question:
How to recycle CA OPS/MVS OPSUSS Servers?
Answer:
To recycle a CA OPS/MVS OPSUSS Server use our product panels to control OSF Servers.
1.- Visit OPSVIEW 4.3 and change the CLASS ===> field from TSO to USS.
2.- Tab next to the server and type the C command to stop the USS Server and hit enter.
The OPSUSS Address Space will be restarted under the same ASID automatically.
If you need to stop them to apply a change then follow these steps:
1.- Visit OPSVIEW 4.1.1 and then set USSMIN to the value '0 SERVERS'.
2.- Lower your current value in the USSDORM to '60 SECONDS', this is the minimum value accepted.
3.- Once you set both parameters wait a minute and confirm the active OPSUSS Servers are stopped and the following messages are seen:
OPS3711I Idle USS server terminated due to MIN and DORM parameters
OPS3714H OSF terminated USS server OPSUSS, ASID=X'005C'
OPS3085H OPSUSS A=92 (X'005C') USS SERVER TERMINATED BY REQUEST .
The ASID value of displayed in the messages above will vary in every site.
Since attempts to manually start OPSUSS Servers by using the MVS START command will result in an abend, consider the following step to restart them:
1.- Visit one more time OPSVIEW 4.1.1 and then modify the USSMIN value back to your original value.
2.- Do the same for the USSDORM parameter you set to '60 SECONDS' earlier.
3.- If you set USSMIN to '1 SERVERS' you should see then the following messages once changes are entered:
OPS1290H your_UID USSMIN 1 SERVERS
In this case one single OPSUSS Server will be started using the next available ASID in the system
OPS3700H OSF now using 1 USS servers - MIN=1 MAX=8
OPS1290H your_UID USSMIN 1 SERVERS
OPS3702H OSF started USS server OPSUSS,ASID=X'005A'
Additional Information:
For more information about the parameter discussed in this article visit the online documentation via this URL link: CA Technologies Documentation
Environment
Component:
Feedback
