Stage#.#####: Failed to resolve endpoints. Reason: 400 BAD_REQUEST "One or more endpoints not found."

Products

• VMware Aria Suite

Issue/Introduction

• In Pipelines within Aria Automation, create a new Pipeline.
• Add an Aria Orchestrator Workflow as 1 stage.
• At the 2nd stage add some additional parameters.
• You notice that this pipeline runs correctly from Pipelines but when we publish this to a catalog then we proceed to hit the error:
  

  • Failed to resolve endpoints. Reason: 400 BAD_REQUEST "One or more endpoints not found."

Environment

• Aria Automation 8.18.1 Patch 1, Patch 2 & Patch 3

Cause

• Customer's pipeline which was created originally in 1 project which is likely shared with another project.
• From the Catalog service, the pipeline was triggered from a different project, the "Pipelines" project, which is treated separately.
  • .
• The "Pipelines" project's model is referring to a vRO endpoint in the task where parameters are set.
• This endpoint was created again in the same project and cannot be accessed from outside this pipeline.
• When the created pipeline is triggered from Catalog ( a different project from "Pipelines"), its not able to find the endpoint and is resulting in expected error with 400 status.
• Directly executing this from the "Pipelines" page works since execution is triggered from "Pipelines" project itself and hence all of the endpoints & variables referred to are accessible.

Resolution

• Recreate all the referred to Endpoints and variables in the "Catalog" project.
  • I.e.: Add the Endpoints and variables as configurable variables to the catalog item