ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

I am getting a 1477 error status after changing a CA IDMS program to use a protocol of DC-BATCH

book

Article ID: 4016

calendar_today

Updated On:

Products

IDMS IDMS - Database IDMS - ADS

Issue/Introduction

After changing a CA IDMS program to use a protocol mode of DC-BATCH it fails with a 1477 error status on the BIND statement. There is only one BIND statement so the rununit has not been bound twice. 

Environment

Release: IDADSO00100-18.5-ADS-for CA-IDMS
Component:

Resolution

With DC-BATCH protocol you need to code a BIND TASK statement at the start of the program before the BIND RUN UNIT and then a FINISH TASK at the end after the FINISH. This will resolve the 1477 error status.