No Flow Data Visible from NSX-T Data Source in Aria Operations for Networks
search cancel

No Flow Data Visible from NSX-T Data Source in Aria Operations for Networks

book

Article ID: 400616

calendar_today

Updated On:

Products

VCF Operations for Networks VMware vSphere ESXi

Issue/Introduction

  • The NSX-T data source was successfully added to VCF Operations for Networks. However, after the integration, no flow data is visible in the platform.
  • As shown in the screenshot below, there are no flows reported under Settings > Accounts and Data Sources, even though the NSX-T data source appears validated.



NOTE:  VCF Operations for Networks was formerly named Aria Operations for Networks (AON), and prior to that was named vRealize Network Insight (vRNI).

Environment

VCF Operations for Networks

 

Cause

One of the most likely causes is that DFW IPFIX is not enabled in Aria Operations for Networks for the configured NSX-T data source, as shown in the screenshot below.

Resolution

In Aria Operations for Networks, the DFW IPFIX feature must be enabled to view flow data from the NSX-T data source.

Refer to the following link to learn how to enable the DFW IPFIX feature in Aria Operations for Networks:

Enable VMware NSX-T DFW IPFIX

Additional Information

If you believe you have encountered this issue and flows are still not visible after enabling DFW IPFIX in Aria Operations for Networks, please open a support case with Broadcom Support and refer to this KB article.
For more information, see Creating and managing Broadcom support cases.