ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
I want to remake 2E MDLLIB library and GENLIB library.
Article ID: 39866
Updated On:
Products
CA 2E
Issue/Introduction
Question:
I want to remake 2E MDLLIB library and GENLIB library.
Should I delete the library and remake MDLLIB again? Or should I execute YCLRMDL command?
Answer:
If progress of the development is an early stage, the YCLRMDL command is effective, too.
The explanation of the YCLRMDL command:
Use the YCLRMDL command without deleting MDLLIB library and the GENLIB library when You want to clear only contents.
I suggest that you make MDLLIB newly using YCRTMDLLIB when you want to inherit the information of the model.
And You can perform YCLRMDL or DELLIB after you shifted in the design information of the old model.
Environment
Release: K1EBAS04400-8.5-2E-400 Toolkit
Component:
Component:
Feedback
Yes
No
Powered by
