Adding a new internal security SYSVIEW Administrator

Products

• SYSVIEW Performance Management

Issue/Introduction

All existing SYSVIEW Security Administrators are no longer with the company.  How can a new one be added?

Resolution

In the SCFGLIB product library (hlq.CNM4SCFG), edit the SYSVIEW System Configuration Options member (probably GSVXGSVX).

Add valid userids to the SYSVIEW Security Administrators section.  At the same time, old invalid userids can be removed.

After saving the changes, either cycle SYSVIEW -or- perform the following instructions to dynamically reload the security changes.

To dynamically issue the reload command from within SYSVIEW take the following steps:  

1.  First verify site's command character. 

    -  go to PROFILE GENERAL 

    - select MISCELLANEOUS

    -  find on MVS COMMAND CHARACTER

(The MVS Command Character will be used to route the command to MVS.  If one isn't specified, enter one now in the VALUE column.)

2.  Then from any screen in SYSVIEW  enter the command: 

   /MODIFY sysvproc,RELOAD SECURITY

         where / = the MVS Command Character found in step 1 above.

                   sysvproc = the name of the SYSVIEW STC proc

If reloading dynamically, it will be necessary to exit SYSVIEW and re-enter for the new security changes to take affect.