ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Unable to modify Capacity of service
Article ID: 39734
Updated On:
Products
CA Application Test
Service Virtualization
CA Continuous Application Insight (PathFinder)
Issue/Introduction
Issue:
Unable to change/update/modify the capacity of a virtual service while deploying or after deployment from console.
Cause:
To be able to change the capacity of any virtual service, the Virtual Service Environment in which it has to be or has been deployed should be started with Performance Mode enabled.
Resolution/Workaround:
1. Set the following in local.properties of the installation where VSE is installed:
lisa.vse.performance.enabled=true
2. Restart VSE component.
Environment
Release: LSVS5099000-9.51-LISA-Virtual Services Environment-up to 50K transactions per da
Component:
Component:
Resolution
Please Update This Required Field
Feedback
Yes
No
Powered by
