NSX groups in Aria Operations for Networks (AON) are not showing the correct members when these groups were defined by criteria
search cancel

NSX groups in Aria Operations for Networks (AON) are not showing the correct members when these groups were defined by criteria

book

Article ID: 394829

calendar_today

Updated On: 05-11-2025

Products

VCF Operations for Networks

Issue/Introduction

In AON UI, the NSX Groups are not showing the members when the groups are defined with a criteria but instead, shows the criteria. When the groups are defined with IP/FQDN, the members are showing up correctly.

NSX groups defined by IP/FQDN (correctly showing the members):

NSX groups defined by criteria (incorrectly showing the criteria as members instead of the actual members):

Environment

VMware vRealize Network Insight 6.9
Aria Operations for Networks 6.10.0
Aria Operations for Networks 6.11.0
Aria Operations for Networks 6.12.0
Aria Operations for Networks 6.12.1
Aria Operations for Networks 6.13.0
Aria Operations for Networks 6.14.0

Resolution

As of today in Aria Operations for network, we do not show the translated members if the membership is defined based on rules/criteria. As a workaround, to look at the actual VMs, this can be viewed by checking on the dashboard of each Security Group. This will be fixed in Aria Operations for Networks future version.
As for the workaround, the members can be viewed by checking the Group dashboard: