What are the valid SSIDMODES to use in the SETUPxx member for DB2 Versions 10, 11 and 12?

Article Id: 39410
Status: Published
Updated On: 14-02-2018 07:54
Legacy Id: TEC1583612
Products:
CA RC/Migrator , CA Endevor SCM Interface , DB2 Administration , CA RC Compare for DB2 for z/OS , CA RC Extract for DB2 for z/OS , CA RC/Query , CA RC Secure for DB2 for z/OS , CA RC Update for DB2 for z/OS , CA Database Analyzer for DB2 for z/OS , CA Fast Unload for DB2 for z/OS , CA Fast Check for DB2 for z/OS , CA Fast Index for DB2 for z/OS , CA Fast Load for DB2 for z/OS , CA Rapid Reorg for DB2 for z/OS
Issue/Introduction:

Question:

What are the valid SSIDMODES to use in the SETUPxx parmlib member for DB2 Version 11 and 12?

 

Answer:

The valid SSIDMODEs for DB2 Version 10, 11 and 12 are:

DB2 V12:             NFN New function not activated
                             NFY New function activated

DB2 V11:             CM       = Conversion mode

                            CM*     = Conversion fallback mode

                            ENFM    = Enable new function mode

                            ENFM*  = Enable new function fallback mode

                            NFM      = New function mode

 

 DB2 V10:            CM8    = Version 8 conversion mode

                            CM8*   = Version 8 conversion fallback mode

                            CM9    = Version 9 conversion mode

                            CM9*   = Version 9 conversion fallback mode

                            ENFM8  = Version 8 enable new function mode

                            ENFM8* = Version 8 enable new function fallback mode

                            ENFM9  = Version 9 enable new function mode

                            ENFM9* = Version 9 enable new function fallback mode

                            NFM    = New function mode

 

This information can be found on the Post Install Help Panel when selecting a SETUPxx member and doing help on 'DB2 Subsystem Mode'.

  

 

Environment:

Release:
Component: GEN