NFA 24.3.6 not processing data after upgrade or install

Products

• Network Flow Analysis

Issue/Introduction

If you recently upgraded your Network Flow Analysis to 24.3.6, you may run into an issue where the data stops processing immediately after:

Environment

Network Flow Analysis 24.3.6

Cause

This is due to a bug in our Harvester code that was introduced in Network Flow Analysis 24.3.6.

Resolution

This is resolved for the Dx NetOps: Network Flow Analysis 24.3.7. For customers running NFA 24.3.6, please see the below patch. The patch will need to be applied to all 24.3.6 NFA Harvester Servers.