BRSA205W and BRSA202E messages when zowe JCLCheck API v2 starts

Products

• JCLCheck Workload Automation

Issue/Introduction

Starting zowe JCLCheck API v2. Received following messages.
Zowe API Mediation Layer is not installed.

hh.mm.ss stcnumbner IEF695I START jckserver   WITH JOBNAME jobname   IS ASSIGNED TO USER stcuser   , GROUP group 
hh.mm.ss stcnumbner $HASP373 jckserver  STARTED                                   
hh.mm.ss stcnumbner IEF403I jckserver - STARTED - TIME=hh.mm.ss                     
hh.mm.ss stcnumbner jchk110I JCL Check v2 startup initiated                     
hh.mm.ss stcnumbner BRSA111I JCL Check v2 startup completed                     
hh.mm.ss stcnumbner BRSA205W JCLCheck? Workload Automation is not registered to Zowe API Mediation Layer. A check will be retried
hh.mm.ss stcnumbner RSA205W JCLCheck? Workload Automation is not registered to Zowe API Mediation Layer. A check will be retried
hh.mm.ss.stcnumbner BRSA202E Unable to connect to Zowe API Mediation Layer and register  
                    or update the service information: JCLCheck? Workload Automation

-　Is there any action required to BRSA205W and BRSA202E messages?
-　Having no Zowe API Mediation Layer, these messages are not required. Is there any way to prevent these messages from being issued ?

Resolution

If the Zowe API Mediation Layer is not installed, BRSA205W and BRSA202E are informational messages. No special action is required.

The messages are not issued when adding 'apiml enabled: false' as shown in the example below in config/jclcheck.yml :

jclcheck:
    maxPoolSize: n
    queueCapacity: nnn
apiml:
    enabled: false