Changes in sub interface configuration on profile is not pushed to the edge.
search cancel

Changes in sub interface configuration on profile is not pushed to the edge.

book

Article ID: 388401

calendar_today

Updated On:

Products

VMware VeloCloud SD-WAN

Issue/Introduction

In some cases when a change is done on the profile level for a sub interface , the change is not synced to the edges in this profile correctly and the sub interface is not created on the edge,

Cause

The issue is caused by bug #154266 where the main interface is overridden at edge-level, the sub interfaces under that interface are not resolved properly in edgeHeartbeat and that is causing this issue.

Issue is seen on all VCO versions before 6.4.

Resolution

Workaround:  Do any dummy change in the UI for a particular edge with issue, then the sub interfaces get resolved by the UI which makes it work even when main interface is overridden at edge-level.

Issue will be resolved in VCO version 6.4