Creating more than 32 VLAN in the same profile on VCO giving limitation error "Number of vlans should be 32 or less"
search cancel

Creating more than 32 VLAN in the same profile on VCO giving limitation error "Number of vlans should be 32 or less"

book

Article ID: 387878

calendar_today

Updated On: 02-17-2025

Products

VMware VeloCloud SD-WAN

Issue/Introduction

Even after increasing number of segments used from 16 to 128 which is the prerequisite to increase the number of VLANs creation within the enterprise (this feature subscription Based and need Premium category ), error message appears that you can't add more than the default limitation "32", as per below example:

 

Environment

VCO/VECO (VeloCloud orchestrator) 

VCE (VeloCloud Edge)

Cause

This feature is interdepended on a system properties on VCO  that needs to be set to 128, but this would be over the whole VCO.

The Default system properties is 16 value and need to be changed to 128 to change the default behavior

Resolution

1-Create support case

2-Refer to this KB

3-Wait for applying the change on VCO (change the system properties needed )in order for applying the feature's configuration change.  

Additional Information

This feature need Edge to be at least 5.2 in order to accept more than 32 VLANs.

You can download the datasheet to confirm that this feature is subscription based feature because it depends on number of segment :

sdwan-712-edge-platform-spec-ds-1020

On-prem setup can get the benefit from this by applying the same change using superuser operator account