How do we identify if any reports have an OPEN status in VIEW?
search cancel

How do we identify if any reports have an OPEN status in VIEW?

book

Article ID: 387020

calendar_today

Updated On:

Products

View

Issue/Introduction

A review of the SARSTC logs shows that the following messages were received during collection of a sysout:

$HASP708 <VIEWDB> SYS00nnn OPEN ERROR - DATASET WAS NOT CLOSED RC=16
                   I/O ERROR READING DATA BUFFER
                  DSNAME=<dbhlq>.<jobname>.<job#>.<D0000nnn>.?
SARJSA05 SUBSYSTEM GET REQUEST FAILED - RPL FEEDBACK 080298

We understand that this may result in the report that was being collected having a status of "OPEN".

How do we identify if any reports have an OPEN status in VIEW?

Environment

View, z/OS, status, of reports, sysouts, open, after, $HASP7080, SARJSA05, ERROR, DATASET, NOT, CLOSED, I/O, READING, DATA, BUFFER, subsystem, get, failed, request, 080298, 0c0204, LOC, field, filter, sysout, selection, list, screen, panel

Cause

Collection of a dataset from JES that was not closed properly.

Resolution

- To determine if you have any OPEN reports in the database, you can use the FILTER for the LOC field shown on the View Sysout Selection List screen.

 

Example before filtering: 

CA View ALL --------------- Sysout Selection List ----------------------------
Command ===>                                                  Scroll ===> CSR 
                                                                              
Sel  Sysout ID                        Arch Date  Time  Loc       Lines   Pages
==>  *                                *          *     *    *          *      
     -QTRLY-REGION=EAST               09/06/2024 10:15 DISK        198       5

 

Example after filtering the LOC field for OPEN reports - Result is no reports in OPEN status, since no reports are listed:

CA View ALL --------------- Sysout Selection List ---------- No sysout selected
Command ===>                                                  Scroll ===> CSR 
                                                                               
Sel  Sysout ID                        Arch Date  Time  Loc       Lines   Pages
==>  *                                *          *     OPEN *          *      
******************************* Bottom of Data ********************************

If a View database does have reports in OPEN status, the resulting Sysout Selection List screen would look similar to the following:

CA View ALL --------------- Sysout Selection List -----------------------------
Command ===>                                                  Scroll ===> CSR 
                                                                               
Sel  Sysout ID                        Arch Date  Time  Loc       Lines   Pages
==>  *                                *          *     OPEN *          *    
     ASB VENDOR BY STATE              09/06/2024 10:08 OPEN       1280      64
     ASB VENDOR BY STATE              09/06/2024 10:01 OPEN       1280      64
     ASB VENDOR BY STATE              09/06/2024 09:24 OPEN       1280      64
******************************* Bottom of Data ********************************

Additional Information

See the following article for process to clean up OPEN reports in View:

Knowledge Article ID: 191000 - SARPAM24 Condition and Reports in OPEN Status