unable to configure port higher than 1050 in apm_bridge probe

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

We have configured our Operator Console to use a nonstandard port for HTTP/HTTPS (e.g. 8080) but the apm_bridge will not allow us to use this port.

The GUI says we have to use a port between 50 and 1050.

 

Environment

DX UIM - Any Version
apm_bridge probe 1.10 or prior

Resolution

This will be resolved in the next release of apm_bridge after 1.10.

A test fix/hotfix is available on the following KB document:  KB384745