Message "invalid operand" is displayed if I attempt to switch DISTID.

Products

• Deliver
• View

Issue/Introduction

Question:
 - I tried to change the DISTID by executing the command MODE distid, but received an "invalid operand" message, why?
 
Answer :
 - Check the userid definition using "DEF USER" command and F11 to go to the right.
 - Make sure the DISTID Mask setting has not been changed, along with other definition settings.
 

Note: a DISTID Mask of * will allow you to switch to any valid distid value defined.

Additional Information :
 - DEF USER command can only be entered by someone with master privileges.

 

Environment

Release: OUTDTI00200-12.1-Deliver-Output Management-Interface for Native TSO
Component: