How do I specify the bandwidth expected on my interfaces in NFA?
search cancel

How do I specify the bandwidth expected on my interfaces in NFA?

book

Article ID: 382035

calendar_today

Updated On:

Products

Network Flow Analysis

Issue/Introduction

How do I override the interface speeds that NFA set via SNMP?

We have found that NFA is reading specifying the percent utilization on our interfaces which appear unrealistic (for example 4000% utilized). 

Is there a way we can specify the value used by NFA?

 

Resolution

 

You should be able to specify the speeds used on each interface. 

From Home, click Administration -> Data Sources-> Network Flow Analysis

This will open the page to Administration: Network Flow Analysis.   On the left pane, select Manage Monitoring:

Then choose the specific Device on the left side.  On the Right side, select Active Intefaces at the top, then Edit that interface in question:

From here you can make the adjustments to the speed: