TPXL0085: SENSE CODE=0000003E MEANING=SENSE CODE UNKNOWN OR TERMINAL OVERRUN
Article ID: 381138
Updated On:
Products
Issue/Introduction
The following messages were in the TPX log, where can more detail be found?
TPXL0050 10/26/24.300 22:55:10.22 LOSTERM EXIT ENTERED FOR SESSION A01SX017
SB: 250F54E8, REASON 20, UNCONDITIONAL TERMINATION
TPXL0085 10/26/24.300 22:55:10.22 RPL ERROR MANAGEMENT ROUTINE ENTERED
PLU=A01SA017 SLU=A01TD002 USER=ABC945XX REQ=22 20001024 00800000 TO
TERMSB=250F54E8 APPLSB=250FA510 EB=21B78F00 RPL=21B78908
RTNCD=10 FDBK2=09 MEANING=UNCOND TERMSELF OR USS LOGOFF
SENSE CODE=0000003E MEANING=SENSE CODE UNKNOWN OR TERMINAL OVERRUN
ACTIONS TO BE TAKEN:
CLSDST
EVENT STORAGE PURGED
Resolution
TPX documentation: TPXL0085
RPL return code (RTNCD / FDB2) > RTNCD=10 FDBK2=09
z/OS 3.1.0- z/OS Communication Server: SNA Programming
|
RTNCD |
FDB2 |
Explanation |
|
16(X'10') |
9 |
Unconditional Terminate or character-coded logoff received |
The logical unit has sent an unconditional Terminate request or a character-coded logoff that is a request for unconditional session-termination. No further communication on the session is possible. CLSDST must be issued.
SNA/VTAM sense codes > SENSE CODE=0000003E
If the VTAM Sense code has X'0000' for the first 2-bytes, then the RPL return-code and feedback code need to be reviewed.
z/OS 3.1.0 - z/OS Communications Server: IP and SNA Codes
TPXL0050 LOSTERM message showing up before TPXL0085 means that the virtual terminal (e.g. A01SX017) was terminated or DLINK'ed. There are many circumstances that can cause LOSTERM (lost terminal) for any active terminal. One of the common reasons is a close out the TN3270 emulator session. When the terminal is not available, VTAM RPL (Request Parameter List) sends out an unconditional termination request for clean-up. When the Users connect to the TPX again, VTAM will assign a new virtual terminal to the TPX for communication.
No actions are required. If ABENDS occur, further diagnosis is required.
Feedback
