processes probe profiles created with "name and command line" are not created correctly

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

In the discovery tab, if you use the "name and command line" option (or the binary path option), when the profile if eventually created, it is created incorrectly, and it's only using the "name".

Environment

• DX UIM 23.4.* 
• processes probe 4.84

 

Cause

Product Defect. When created using "name and command line", Profiles are only using the name, resulting in incomplete or incorrect profile information. 

Resolution

The attached processes probe version addresses this issue: processes_4.84-HF1

Fix for this issue included in the Hotfix: 

Resolved an issue where profiles created using the "name and command line" or binary path option in the Discovery tab were not created correctly. Previously, profiles were only using the name, resulting in incomplete or incorrect profile information. This issue has been addressed in this hotfix.

Additional Information

• Attached, are also the Release notes with the complete list of fixes. 
  
  
• Related KB: "on Action" alarms from the processes probe don't clear when the process starts again