Introduction:
This document describes how to correct DT601I & SA021I messages & enable viewing of Detector & Subsystem Analyzer collections when running both products using separate Xmanagers and XMANIDs.
Question:
I am unable to see my Detector & Subsystem Analyzer collections when attempting to run both products using separate Xmanagers & XMANIDs. Instead, I'm receiving DT601I & SA021I messages. How can I correct this problem?
Environment:
z/OS 1.11 and above.
Answer:
The 2 steps below can correct this problem:
1) Ensure that the XSYS parameters in both Xmanagers are set to (Y)
2) Afterwards, recycle both Xmanagers