Verify the setting for AllowUserKeyCSA

Products

• IDMS

Issue/Introduction

AllowUserKeyCSA(NO) will cause SB78-5C or S0C4 at startup if the instructions at SB78 REASON CODE 0000005C abend at IDMS startup after ALLOWUSERKEYCSA(NO) have not been used to setup IDMS for this parameter. Is it possible to verify the setting for AllowUserKeyCSA while the system is up?

Environment

Release: All supported releases.

Resolution

z/OS Console Command D DIAG will display the AllowUserKeyCSA setting.

Example of the display from this command:

IGV007I 15.55.44 DIAG DISPLAY 463
VSM TRACK CSA(ON) SQA(ON)
VSM TRACE GET(OFF) FREE(OFF)
VSM ALLOWUSERKEYCSA(NO)
CBLOC
  VIRTUAL24()
  VIRTUAL31()
REUSASID(NO)

 

Additional Information

ALLOWUSERKEYCSA default changed in z/OS version 1.9