Host status 'unknown' in vLCM

Products

• VMware vSphere ESXi
• VMware vCenter Server

Issue/Introduction

• Scenario 1:
  • The ESXi host status is showing as 'unknown' after remediation:

ACTIONS ⇓

? Host status is unknown
Info: The host will be rebooted during remediation.
Info: Quick Boot is supported on the host.

Firmware compliance

• Scenario 2:
  • Or the ESXi host stops part-way through remediation and produces the error:

Host status is unknown

The host could not be reached, and its image compliance could not be checked. Try refreshing image compliance again - the host may be reached successfully.

During remediation, this host may get remediated if it can be reached successfully.

Environment

VMware vSphere Esxi 7.x

VMware vSphere Esxi 8.x

VMware vCenter Server 7.x

VMware vCenter Server 8.x

Cause

Communication issues between the ESXi host and the vCenter/vLCM application.

Resolution

• Resolution 1
  • This issue can also occur due to incorrect entry of vCenter server Ip in esxi host's /etc/hosts file.
  • To fix it, remove incorrect entries from /etc/hosts file and add correct entries:
  • Refer: Adding/Deleting/Editing a host entry on vCenter server or ESXi host using vi editor
• Resolution 2
  • Initially try doing a disconnect & reconnect the ESXi host in vCenter Inventory.
  • If that doesn't resolve the issue, gracefully reboot ESXi host.
• Resolution 3
  • Confirm that the physical networking infrastructure in the affected environment is operating at optimal (Check with your internal networking team to ensure this).