Create a custom clear alarm in the ldap_response probe

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

We have created an LDAP profile and under the alarm messages section, we can enter custom alarm messages.

However, there is no option to create a clear message. But the clear message is there by default but not configurable. This "clear message" option is typically available for most of the probes that are present by default in the GUI.

1. Is this behavior intentional for LDAP profiles?
2. If not, is there a workaround to allow the customer to set clear messages?
3. Should we consider adding this feature to align with other probe configurations?

 

Environment

DX UIM any version

ldap_response probe: 1.35

 

Cause

Limitation

Resolution

The ldap_response probe clear message is present by default. However, this clear message is not configurable.

The ability to set a custom CLEAR message is not currently available.

This limitation is part of the current design of the probe. If you require the ability to configure a custom clear message using the ldap_response probe, you will need to submit an enhancement request.

Additional Information

How to raise an enhancement request for DX UIM