DBUTLTY LOAD S0C1 and S0C4 abends after dynamic extend
search cancel

DBUTLTY LOAD S0C1 and S0C4 abends after dynamic extend

book

Article ID: 378217

calendar_today

Updated On:

Products

Datacom/DB DATACOM - AD Datacom/AD Datacom

Issue/Introduction

Running a Datacom DBUTLTY LOAD into an area that becomes full and causes a dynamic extend to occur.
After the dynamic extend completes the LOAD abends with a S0C1 in DBFSXPR +15E followed by a S0C4 in DBCFMPR +13D2.
Error Messages:

DB01706I - DYNAMIC EXTEND END aaabbb CYL 11,750 vvvvvv VOL 3 VOLS 3 EXT 2 CYL +200  

 SYSTEM COMPLETION CODE=0C1  REASON CODE=00000001 
  PSW AT TIME OF ERROR  078D0000   9752815E  ILC 2  INTC 01 
  ACTIVE MODULE           ADDRESS=00000000_17528000  OFFSET=0000015E 
  NAME=DBFSXPR

 SYSTEM COMPLETION CODE=0C4  REASON CODE=00000004 
  PSW AT TIME OF ERROR  478D0000   9294B3D2  ILC 4  INTC 04 
  ACTIVE MODULE           ADDRESS=00000000_1294A000  OFFSET=000013D2 
  NAME=DBCFMPR 

 IEF450I jobname stepname  - ABEND=S0C4 U0000 REASON=00000004  

Environment

Release: 15.1

Cause

This is caused by a bug in the Datacom code.

Resolution

Apply PTF LU12903 and rerun the LOAD.

Alternatively re-allocate the file large enough so it does not have to do a dynamic extend and rerun the LOAD.