Unable to GENERATE the SOURCE for an object.

Products

• CA 2E

Issue/Introduction

While attempting to generate source content for an object, the YGENSRC job fails with an error message "Object XXXX in QTEMP type *FILE not found"

Message . . . . : Object XXXX in QTEMP type *FILE not found.
Cause . . . . . : No object was found for the name or type specified.
Recovery . . . : Specify the correct name or type of the object. Then try the request again.

Environment

CA 2E 8.7.3 and above

Cause

Issue may arise if the source member was locked by a DEBUG on another session.

Resolution

Ensure that there is no lock on the source member

If you require further assistance, please contact Broadcom Support.