show_usage_data cannot be run on a Control Center only system
search cancel

show_usage_data cannot be run on a Control Center only system

book

Article ID: 373208

calendar_today

Updated On:

Products

Messaging Gateway

Issue/Introduction

When attempting to run the show_data_usage command on a Messaging Gateway Control Center host, the command returns the error that the command needs to be run on a Control Center:

cc [10.9.0-3]> show_usage_data

show_usage_data must be run on a Control Center

Environment

Version: 10.8, 10.9.0

Cause

This is a defect which causes the command to fail to recognize Control Center only hosts as valid for the command execution. The show_usage_data command should run on both a Control Center only host or a combination Control Center + Scanner but currently only runs on a combination Control Center + Scanner host.

Resolution

This defect will be addressed in the SMG 10.9.1 release.

Currently there is no workaround.