ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Double traffic using netflow flexible V9 config
Article ID: 37310
Updated On:
Products
CA Network Flow Analysis (NetQos / NFA)
Issue/Introduction
Issue:
Using NFA 9.3.x, there is double traffic displayed in the NFA reports for some interfaces.
Environment:
NFA 9.3.x on win2008/win2012 with CISCO routers using flexible netflow
Cause:
egress + ingress traffic is displayed instead of ingress traffic or egress traffic
Resolution:
You must add in the flexible netflow config the field direction:
match flow direction
Environment
Release: RAIB1H99000-9.3-Network Flow Analysis-Interface Bundle-Hardware
Component:
Component:
Feedback
Yes
No
Powered by
