Update SAP_XBP2 Uproc from JobChain fails with Cannot retrieve the node configuration from builder context

Products

• CA Automic Dollar Universe

Issue/Introduction

UVC loses the correct context when editing a SAP_XBP2 Uproc belonging to a Job Chain when two or more nodes as selected in the list of nodes in menu Monitoring - Monitoring - Job Chains.
If a Job Chain is opened in mode monitor, then you double click in the Uproc SAP_XBP2, it opens the display of the Uproc, if you click in the keylock, it will go into Modification mode and here if you click in Edit (to edit the steps of the uproc), a popup error appears with the following:

On environment [COMPANY/NODE/X]:
Update Uproc on NODE:
Cannot retrieve the node configuration from builder context

Expected behavior: same as when one single node is selected, there should be no error and the SAP manager active and related configuration should be properly retrieved. 
Actual behavior: an exception occurs and uproc SAP_XBP2 cannot be edited from the Job Chain if multiple nodes are selected in the Monitoring menu.

Environment

Dollar Universe 6.x and 7.x

Cause

Defect in UVC

Resolution

Update to a fix version listed below or a newer version if available.

Fix version(s): 
Component: Univiewer Console
Will be fixed on Dollar Universe 7.01.01 - planned release end September 2024

Additional Information

Defect ID: DU_AS-7629